[Video]The Video of Jaring Undercut Portable Drilling Machine

  Now many new clients ask us if we have the video of how to use Jaring Undercut Bolt Portable Drilling Machine. Yes,we have the video,but it's big file,we can't put it in the company web,otherwise our web will be very slow when you open it.

  If you also need the video of Jaring Manual Drilling Machine ,please call us or email us,we can send you by email or send it to you by third web.(www.wetransfer.com / www.transferbigfiles.com)

  If you have bought our jaring undercut drilling machine,please don't worry,we have put the Operating Instructions of our machine in the carton and video of operating jaring machine in the USB Disk.

  Attached some screenshot of important steps of undercut anchor drilling machine ,please check them.

 Please put the undercut anchor drilling machine on the stone panel,open the air compressor to make the machine on the panel steady.

Make sure the water is run through the drill bit,first press down the long handle for drilling the straight hole,then press down the short handle for undercut bottom.

Check the new undercut hole,if technical data all right,fix the anchor,then tightened the screw.

This photo tell you how to change the undercut anchor drill bit easily,press down the short handle,the drill bit will be out.

After many times drilling,we should change the new silicone sealing strip to make sure the undercut anchor drill machine is not waggle on the panel when working. 

For more information about Undercut Bolt Drilling Machine.

Jaring Facades always provide good quality products and best after sale service.  

All Rights Reserved.